Plug the washing machine back in and then within 30 seconds quickly open and close the lid six times.
Ge top load washer lid lock flashing.
If f8 e1 or lf too long to fill appears in the display the washer is taking too long to fill or the washer is filling and draining.
Top load washer lid lock feature.
You cannot set the washer to lock for the entire cycle.
Top load washers consumer help indicator.
Placing a separate magnet there will create a stable electromagnetic connection with the solenoid and trick the machine into thinking that the lid is.
Sensing sensing load size and type before and during fill normal.
It s possible the drain hose extends more than 4 5 114 mm into the standpipe.
To reset washing machines that use the ge hydrowave system start by unplugging the washer for one minute.
You ll need to do this within a 12 second period.
Models with precise fill load sensing will lock during the load sensing period and.
High efficiency diamond gray top load washing machine with smart dispense and sanitize with oxi energy star 944 00.
Just under the unit s housing at this spot there is a solenoid which is a type of powerful electromagnet.
I have an older kenmore top loading washing machine.
Raise the lid at least 2 inches and make sure it closes each time.
Most washing machines come equipped with a lid switch.
Lid cycle stopped because lid is open.
When 4 cycles are completed without the lid switch opening the inverter control assumes that the lid switch is defective.
However some washing machines come with a lid lock.
The inverter control expects to see the lid switch open after every cycle.
I did some google searching and found that there could be a few different issues that are causing the lid lock light to flash or blink on the control panel of my washer.
I do not lid lock light flashing blinking on top load washing machine how to clear read more.
This switch is connected to a solenoid that completes a circuit allowing the machine to run only if the top is down.
Unplug the washer and repair or replace the lid switch wire harness.
The lid lock light is flashing on my top load washer.
Press start button again to restart the cycle.
Pause cycle paused because the start pause button was pressed and the washer was set to pause.
Set a magnet on the site where the lid lock switch meets the washer cabinet.
Get free shipping on qualified ge top load washers or buy online pick up in store today in the appliances department.
Starting in 2015 top load washers feature a lid lock that engages when the washer is either load sensing before and during fill or when it is spinning above 50 rpm.
