You push the button to close the garage door.
Garage door closes and opens again help.
This is done with the help of sensors in the motor and on each side of the opening near the floor and mounted on the tracks.
This is almost always the result of a dirty or obstructed safety feature.
As these wires short against the housing the electrical impulse causes the door opener to activate.
Your garage door most likely uses two sensors to trigger its reverse mechanism.
But changes in weather conditions can causes your garage door components to shift or contract.
They are usually on the motor housing and you access them by opening a panel or removing the housing cover.
If it closes before that distance has been traveled it thinks something is wrong and it reopens to help prevent any damage or safety risk.
One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door.
If the door stops short of closing lengthen the close limit by turning the control knob in the direction indicated usually counterclockwise.
Below are three reasons why your garage door opens on its own and some quick fixes you can try.
Whether you re using the passcode entry the buttons inside the garage or your remote opener the openers and the garage door itself must be on the same frequency.
Garage doors use radio frequencies to open and close.
In garage door operators made after 1993 there are required safety features that open the door during the close cycle when they detect something blocking the door.
If you clear all debris and any buildup from the sensors near the floor of your garage door tracks but the motion of your garage door tends to be partially closing and then reversing and opening again you may have a misaligned sensor.
When that happens the distance your garage door needs to travel may change.
Close the door with either the door control or the remote control.
Most garage door openers have an open and close limit control.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
This page should help you troubleshoot your garage door problems.
The symptom of this is a garage door that is in constant motion opening fully then immediately descending only to start the same cycle again.
Scan the safety sensors.
Pull the emergency release handle down and back towards the garage door opener.
This will disconnect the garage door opener from the door.
To fix this issue and get your liftmaster garage door opener working again follow these troubleshooting steps.
While many problems that keep the door from opening are caused by broken springs a lot of other parts could be keeping your door from functioning properly.
